Makerbot: Difference between revisions
No edit summary |
|||
Line 27: | Line 27: | ||
== Plastruder MK3 Assembly == | == Plastruder MK3 Assembly == | ||
[http://wiki.makerbot.com/plastruder-mk3-assembly Instructions] | [http://wiki.makerbot.com/plastruder-mk3-assembly Instructions] | ||
Progressed through to end of Heater Barrel Assembly. | |||
Progressed through to end of Heater Barrel Assembly. [[User:Miloh|Miloh]] 04:24, 21 July 2009 (PDT) | |||
Continue at Filament Drive Mechanism. | |||
Progressed through the Filament Drive Assembly, and Joachim mastered the electronics. [[User:Miloh|Miloh]] | |||
Continue at Attach Heater Barrel. |
Revision as of 02:01, 24 July 2009
Building
This describes the current progress of the building of the Makerbot. Instructions are found here, and a forum for it is found here.
Noisebridge's Makerbot kit, thoughtfully purchased by Mitch, arrived at 83C on Monday evening, July 20. Leading the assembly team is Joachim, along with Christoph, Rachel, Steve (Mr Domino), and Jeffrey (ieatlint).
It took about an hour and a half to go through and check the parts against the parts list. We think we are missing a bag of "laser cut pulleys" but it's hard to be completely sure, as there are a LOT of parts and they are not all labeled exactly as in the parts list A bag of "laser cut pulleys" was replaced by MakerBot-made pulleys, but the parts lists weren't updated. We determined to start assembly anyway.
Cupcake Electronics Assembly
Instructions Christoph soldering one of the stepper motor drivers, one of the endstop switches, and the SMD parts on the motherboard with only occasional bitching to people to STOP MOVING THE TABLE.
Cupcake Pulley Assembly
Cupcake CNC Body Assembly
We got the first part of the body together without difficulty, but had trouble with the Z stage as one of the parts had changed from when the docs were written. The Z stage rod holding guides changed from being O-shaped to being U-shaped, and are marked "Z guides". The forums told us to use them anyway.
The next problem was with threaded rods, which had been cut to size. The ends of some would not take a nut. We solved this with judicious use of the bench grinder. There were LOTS of nut/rod jokes, and we were in a state where they were actually funny! Rachel 10:08, 21 July 2009 (PDT)
Progressed to and including the step entitled "Z-stage stepper wiring" as detailed on the body assembly instructions. The body assembly is nearly completed. Ieatlint 03:52, 21 July 2009 (PDT)
Cupcake Y Stage Assembly
Cupcake X Stage Assembly
Plastruder MK3 Assembly
Progressed through to end of Heater Barrel Assembly. Miloh 04:24, 21 July 2009 (PDT)
Continue at Filament Drive Mechanism.
Progressed through the Filament Drive Assembly, and Joachim mastered the electronics. Miloh
Continue at Attach Heater Barrel.