Maker Faire Build Night 2015-03-19: Difference between revisions
No edit summary |
No edit summary |
||
Line 8: | Line 8: | ||
===Table Part cutting=== | ===Table Part cutting=== | ||
Depending on attendance, we will also start cutting the other parts for the table and labeling them for future use. | Depending on attendance, we will also start cutting the other parts for the table and labeling them for future use. | ||
==Here is how it went== | |||
The project continues. | The project continues. | ||
Line 14: | Line 16: | ||
http://runningahackerspace.tumblr.com/post/100011722093/freehanding-because-you-dont-have-a-shopbot | http://runningahackerspace.tumblr.com/post/100011722093/freehanding-because-you-dont-have-a-shopbot | ||
The table top and substructure have been cut. It took a while, but we are ready to start turning this thing into a table. | |||
[[File:Plotted_Logo_2015-03-19.jpg|none|640px|thumb|Inkjet plotter.. cheating?]] | |||
[[File:Plotted_Logo_2015-03-19.jpg|none|640px|thumb| | To get the logo on the table I used a full size print of the logo. This works by printing out the design that one wants to transfer then scribbling over the line work on the backside of the paper with pencil. Once the back of the design is covered, the transfer is placed on the destination surface and one carefully traces over the design. This leaves a line of pencil lead on the destination surface. | ||
[[File:Darken_the_line_2015-03-19.jpg|none|640px|thumb|CAPTION]] | [[File:Darken_the_line_2015-03-19.jpg|none|640px|thumb|CAPTION]] |
Revision as of 21:23, 24 March 2015
This is part of the Noisebridge Booth for Maker Fair 2015 project
Goals and Tasks
Routing
We well transfer the NB logo on to the finish surface and then carefully and painstakingly route the NB logo into it. This will be a long process and will likely take the entire build night.
Table Part cutting
Depending on attendance, we will also start cutting the other parts for the table and labeling them for future use.
Here is how it went
The project continues.
So this seems apt: http://runningahackerspace.tumblr.com/post/100011722093/freehanding-because-you-dont-have-a-shopbot
The table top and substructure have been cut. It took a while, but we are ready to start turning this thing into a table.
To get the logo on the table I used a full size print of the logo. This works by printing out the design that one wants to transfer then scribbling over the line work on the backside of the paper with pencil. Once the back of the design is covered, the transfer is placed on the destination surface and one carefully traces over the design. This leaves a line of pencil lead on the destination surface.
TEXT
TEXT
TEXT
TEXT
TEXT
TEXT
TEXT
TEXT